brake light switch
|
02-19-2008, 02:57
Post: #1
|
|||
|
|||
brake light switch
Bruce,
On my 1986, I found a terminal strip with the wiring (labeled by the factory) inside the generator battery compartment, street side, in the same compartment as the windshield washer reservoir tank. Maybe you can be as lucky?
Kevin McKeown
Yorba Linda, CA
1986 38' PT
In a message dated 2/19/2008 10:20:34 A.M. Pacific Standard Time, birdshill123@... writes:
Delicious ideas to please the pickiest eaters. Watch the video on AOL Living. |
|||
02-19-2008, 06:19
Post: #2
|
|||
|
|||
brake light switch
I am going to install a US Gear Unified brake system on our 88 FC. I
have installed these before. However, where do I find the brake light switch or the wiring that leads to the switch ? Is it under the floor by the treadle. Thanks Bruce 1988 FC35 |
|||
02-19-2008, 06:33
Post: #3
|
|||
|
|||
brake light switch
HI Bruce:
Yes, there are 2 switches. They are usually installed directly on the break valve (front/rear) or they may have been routed to header usually found in the drivers side front compartment. Safe travels, Ralph and Charolette Fullenwider 84FC35 "Ruff Diamond" Duncan, Oklahoma At 06:19 PM 2/19/2008 +0000, you wrote: >I am going to install a US Gear Unified brake system on our 88 FC. I >have installed these before. However, where do I find the brake light >switch or the wiring that leads to the switch ? Is it under the floor >by the treadle. > >Thanks > >Bruce >1988 FC35 > > > |
|||
02-19-2008, 10:23
Post: #4
|
|||
|
|||
brake light switch
Bruce,
There is one in the battery bay driver side. As Ralph suggests there is a header bracket just about an inch above the batteries, mounted to a bracket with an air manifold. Not sure of # 2. Bill 88 FC Michigan --- In WanderlodgeForum@yahoogroups.com, "Ralph L. Fullenwider" > > HI Bruce: > > Yes, there are 2 switches. They are usually installed directly on the break > valve (front/rear) or they may have been routed to header usually found in > the drivers side front compartment. > > Safe travels, > > Ralph and Charolette Fullenwider > 84FC35 "Ruff Diamond" > Duncan, Oklahoma > > At 06:19 PM 2/19/2008 +0000, you wrote: > >I am going to install a US Gear Unified brake system on our 88 FC. I > >have installed these before. However, where do I find the brake light > >switch or the wiring that leads to the switch ? Is it under the floor > >by the treadle. > > > >Thanks > > > >Bruce > >1988 FC35 > > > > > > > |
|||
02-19-2008, 11:26
Post: #5
|
|||
|
|||
brake light switch
Thanks for the replies. That is going to make it very easy to tap into
the brake switch circuitry. Bruce 1988 FC35 |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)