I am going to install a US Gear Unified brake system on our 88 FC. I
have installed these before. However, where do I find the brake light
switch or the wiring that leads to the switch ? Is it under the floor
by the treadle.
Thanks
Bruce
1988 FC35
HI Bruce:
Yes, there are 2 switches. They are usually installed directly on the break
valve (front/rear) or they may have been routed to header usually found in
the drivers side front compartment.
Safe travels,
Ralph and Charolette Fullenwider
84FC35 "Ruff Diamond"
Duncan, Oklahoma
At 06:19 PM 2/19/2008 +0000, you wrote:
>I am going to install a US Gear Unified brake system on our 88 FC. I
>have installed these before. However, where do I find the brake light
>switch or the wiring that leads to the switch ? Is it under the floor
>by the treadle.
>
>Thanks
>
>Bruce
>1988 FC35
>
>
>
Bruce,
There is one in the battery bay driver side.
As Ralph suggests there is a header bracket just about an inch above
the batteries, mounted to a bracket with an air manifold.
Not sure of # 2.
Bill 88 FC Michigan
--- In
WanderlodgeForum@yahoogroups.com, "Ralph L. Fullenwider"
wrote:
>
> HI Bruce:
>
> Yes, there are 2 switches. They are usually installed directly on
the break
> valve (front/rear) or they may have been routed to header usually
found in
> the drivers side front compartment.
>
> Safe travels,
>
> Ralph and Charolette Fullenwider
> 84FC35 "Ruff Diamond"
> Duncan, Oklahoma
>
> At 06:19 PM 2/19/2008 +0000, you wrote:
> >I am going to install a US Gear Unified brake system on our 88
FC. I
> >have installed these before. However, where do I find the brake
light
> >switch or the wiring that leads to the switch ? Is it under the
floor
> >by the treadle.
> >
> >Thanks
> >
> >Bruce
> >1988 FC35
> >
> >
> >
>
Thanks for the replies. That is going to make it very easy to tap into
the brake switch circuitry.
Bruce
1988 FC35