Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Generator Slide
03-21-2013, 11:49 (This post was last modified: 03-21-2013 11:50 by csprenger.)
Post: #4
RE: Generator Slide
It was suggested to watch the slide and release the in/out switch right at the time the slide reaches either direction, no clattering. Watching the sliding so the out/in switch is released before ratcheting the motor/clutch, the tray moves in either direction without the noise. Stop switches would be nice but some fabrication is needed. I'm not out of BB stuff to do so will not take on the stop switch project at this time.

Curt Sprenger
1987 PT38 "MacAttack Racing"
Anaheim Hills, CA
cosresources@gmail.com
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 


Messages In This Thread
Generator Slide - csprenger - 03-19-2013, 16:39
RE: Generator Slide - DOSZORROS - 03-19-2013, 18:24
RE: Generator Slide - Itchintogo - 03-20-2013, 19:25
RE: Generator Slide - csprenger - 03-21-2013 11:49
RE: Generator Slide - cire - 03-21-2013, 13:32
RE: Generator Slide - Arcticdude - 03-21-2013, 14:46
RE: Generator Slide - cmillsap - 07-22-2014, 20:35
RE: Generator Slide - GregOConnor - 08-19-2014, 13:36
RE: Generator Slide - RetDA - 08-20-2014, 07:51
RE: Generator Slide - Bamagfc - 09-08-2015, 00:13
RE: Generator Slide - davidbrady - 09-08-2015, 12:10
RE: Generator Slide - cmillsap - 09-08-2015, 14:23
RE: Generator Slide - Bamagfc - 09-08-2015, 23:35
RE: Generator Slide - GregOConnor - 09-09-2015, 01:30



User(s) browsing this thread: 1 Guest(s)