Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Slideout Issue
05-15-2013, 16:43
Post: #25
RE: Slideout Issue
(05-15-2013 15:52)BillR Wrote:  I have a 99 LXi with two slides. I have not had any problems (knock on wood) but given O'Malley's Law (it states: Murphy was an optimist) I would like to be prepared in the event one of them decides it doesn't want to be retracted.

I went searching and found this posted in December of 2009 by David Brady:

"Here's how slide operation works for 95% of LXi owners:
1) level the coach
2) turn the deflate seal key,
3) push and hold the extend button, voila, done.

The important stuff is in my first post which was taken from HWH documentation. It states what's important. I added the rest, intending it as thorough documentation for future generations of BB owners. I see someone 5 years from now doing a search on slides and stumbling upon my post. I'm here to serve."

Well, it hasn't been quite 5 years but I did stumble on it Smile

My question is, is there way to manually get a slide back in on an LXi if need arises? I have seen some that will accept a crank or a ratchet and can be manually brought in but have NO idea how (or if) it can be done with the Wanderlodge. I'm sure if the need does arise, I will be at least 500 miles from home and 100 miles from a competent mechanic.

Bill,

I might add a few precautions when operating the slide. Johnney Anderson (Bluebird Tech) instructions are:

Extend:
A) Plugged to shore power or Generator running
B) Pilot seat forward
1) Engine running
2) Dump suspension
3) Auto level coach
4) Check & close all bay doors and determine no other obstructions
5) Turn slide Key on.
6) Wait untill yellow light comes on (up to 45 seconds)
7) Push Extend slide button and hold until Red Pump light goes off.
8) Turn slide key off
9) Stop engine

Retract
A) Plugged to shore power or Generator running
B) Pilot seat forward
1) Engine running
2) Re-Level coach (Slide has Zero Tollerance)
3) Re-Check & close all bay doors
4) Turn slide Key on.
6) Wait untill yellow light comes on (up to 45 seconds)
7) Push Retract slide button and hold until Red Pump light goes off.
8) Turn slide key off
9) Store Hydraulic Jacks
10) Suspension Dump OFF

This thread should serve as a reminder to retract any awning extensions before retracting slide.

Chuck & Tela Millsap
2003 Prevost Marathon XLII
2000 LXi #2 S/S (Sold)
2004 M380 D/S (Sold)
2000 LXi #1 N/S (Sold
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 


Messages In This Thread
Slideout Issue - cmillsap - 05-09-2013, 00:10
RE: Slideout Issue - davidbrady - 05-09-2013, 00:54
RE: Slideout Issue - cmillsap - 05-09-2013, 10:34
RE: Slideout Issue - davidbrady - 05-09-2013, 10:34
RE: Slideout Issue - csprenger - 05-09-2013, 12:56
RE: Slideout Issue - al perna - 05-09-2013, 20:35
RE: Slideout Issue - cmillsap - 05-11-2013, 00:09
RE: Slideout Issue - davidbrady - 05-09-2013, 22:03
RE: Slideout Issue - cmillsap - 05-09-2013, 23:37
RE: Slideout Issue - davidbrady - 05-10-2013, 10:07
RE: Slideout Issue - davidbrady - 05-11-2013, 10:11
RE: Slideout Issue - cmillsap - 05-11-2013, 12:27
RE: Slideout Issue - al perna - 05-11-2013, 10:21
RE: Slideout Issue - davidbrady - 05-11-2013, 10:33
RE: Slideout Issue - davidbrady - 05-11-2013, 12:44
RE: Slideout Issue - cmillsap - 05-11-2013, 13:25
RE: Slideout Issue - davidbrady - 05-11-2013, 15:19
RE: Slideout Issue - al perna - 05-11-2013, 16:52
RE: Slideout Issue - davidbrady - 05-11-2013, 17:22
RE: Slideout Issue - al perna - 05-11-2013, 21:08
RE: Slideout Issue - davidbrady - 05-12-2013, 11:25
RE: Slideout Issue - Arcticdude - 05-12-2013, 15:21
RE: Slideout Issue - BillR - 05-15-2013, 15:52
RE: Slideout Issue - cmillsap - 05-15-2013 16:43
RE: Slideout Issue - davidbrady - 05-15-2013, 16:39
RE: Slideout Issue - Arcticdude - 05-15-2013, 22:46
RE: Slideout Issue - BillR - 05-16-2013, 11:40
RE: Slideout Issue - davidbrady - 05-16-2013, 11:56
RE: Slideout Issue - BillR - 05-16-2013, 12:54
RE: Slideout Issue - davidbrady - 05-31-2013, 13:44
RE: Slideout Issue - pgchin - 06-07-2013, 10:35
RE: Slideout Issue - cmillsap - 06-26-2013, 20:48



User(s) browsing this thread: 4 Guest(s)