Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Entry door weather seal
02-09-2010, 12:17
Post: #1
Entry door weather seal
My entry door weather seal is shot, pieces starting to fall off.

A search turned up a thread by Stephen Birtles in August about some M450 door
seals he had acquired, and there was an open question about what else they might
work for. I called him, and they are definitely not right for my coach. So the
starting point is to describe what I have. I couldn't get a picture to show it
adequately, so I'm trying a drawing instead. There are two "wipers" with a
shorter one that goes in to the frame and a longer one that contacts the edge of
the frame:

See the drawing here: http://www.arcatapet.net/image/doorseal.jpg

First question: has anyone found a replacement for these?

Second question: is this the same as your coach/year/model? If so, are you in
need of replacement?

The second question(s) are important if there is no answer to the first one.
Enough demand and Stephen can probably get something made.

Don Bradner
90 PT40 "Blue Thunder"
My location: http://www.bbirdmaps.com/user2.cfm?user=1
Quote this message in a reply
02-09-2010, 12:38
Post: #2
Entry door weather seal

Don
Back when I replaced the one on my SP36, Holland Motor Homes in San Diego had a whole roll of it.(500ft. I think)
Also you may look at the Orr & Orr catalog.
Fred & Jeanne Hulse
Morristown Arizona
1997 Wanderlodge WLWB41
Quote this message in a reply
02-09-2010, 15:25
Post: #3
Entry door weather seal
I have none of the original seal left and would take some. It looks like a seal based on your drawing would work on mine.
Rick and Marilyn Davis
1993 WBSA
Loudon, TN



From: Don Bradner
To: WanderlodgeForum@yahoogroups.com
Sent: Tue, February 9, 2010 6:17:49 PM
Subject: [WanderlodgeForum] Entry door weather seal



My entry door weather seal is shot, pieces starting to fall off.

A search turned up a thread by Stephen Birtles in August about some M450 door seals he had acquired, and there was an open question about what else they might work for. I called him, and they are definitely not right for my coach. So the starting point is to describe what I have. I couldn't get a picture to show it adequately, so I'm trying a drawing instead. There are two "wipers" with a shorter one that goes in to the frame and a longer one that contacts the edge of the frame:

See the drawing here: http://www.arcatape t.net/image/ doorseal. jpg

First question: has anyone found a replacement for these?

Second question: is this the same as your coach/year/model? If so, are you in need of replacement?

The second question(s) are important if there is no answer to the
first one. Enough demand and Stephen can probably get something made.

Don Bradner
90 PT40 "Blue Thunder"
My location: http://www.bbirdmaps. com/user2. cfm?user= 1

Quote this message in a reply
02-09-2010, 19:08
Post: #4
Entry door weather seal
I used some that I found at O'reilly's 5 yrs ago now. Still sealing just fine.

2000LXI in SPI

--- In WanderlodgeForum@yahoogroups.com, "Don Bradner" wrote:
>
> My entry door weather seal is shot, pieces starting to fall off.
>
> A search turned up a thread by Stephen Birtles in August about some M450 door
seals he had acquired, and there was an open question about what else they might
work for. I called him, and they are definitely not right for my coach. So the
starting point is to describe what I have. I couldn't get a picture to show it
adequately, so I'm trying a drawing instead. There are two "wipers" with a
shorter one that goes in to the frame and a longer one that contacts the edge of
the frame:
>
> See the drawing here: http://www.arcatapet.net/image/doorseal.jpg
>
> First question: has anyone found a replacement for these?
>
> Second question: is this the same as your coach/year/model? If so, are you in
need of replacement?
>
> The second question(s) are important if there is no answer to the first one.
Enough demand and Stephen can probably get something made.
>
> Don Bradner
> 90 PT40 "Blue Thunder"
> My location: http://www.bbirdmaps.com/user2.cfm?user=1
>
Quote this message in a reply
02-10-2010, 15:22
Post: #5
Entry door weather seal
This looks like the same cross section that my door is sealed with. I need to
replace mine at this time. I sure would be interested if you find a source.

Eric Perplies
96 PT-42
Quote this message in a reply
02-10-2010, 16:55
Post: #6
Entry door weather seal
If there is a source it apparently would have to be one of the old-line BB
dealers like Holland or Bleakley.

Consensus seems to be that changing to a bulb-type seal is better than stock -
the stock is a bit too thick and requires door slamming to close.

Randy says he uses the double-d channel and separates it to use one side. Since
I'm unlikely to be around an HD or Lowes for several months I ordered this one
this morning: http://www.amazon.com/gp/product/B000HE7YQM

On 2/11/2010 at 3:22 AM Eric wrote:

>This looks like the same cross section that my door is sealed with. I
>need to replace mine at this time. I sure would be interested if you find
>a source.
>
>Eric Perplies
>96 PT-42
Quote this message in a reply
02-11-2010, 00:52
Post: #7
Entry door weather seal
Don, it seems Amazon is a one stop shopping. I like the fact that they don't charge sales tax and free shipping is a plus, also.
Also- yoou don't have to drive all over checking out the box stores where the employees don't have a clue.

Ernie Ekberg
83PT40
Wanderlodge
Weatherford, Tx 817-475-3991

--- On Wed, 2/10/10, Don Bradner wrote:

From: Don Bradner
Subject: Re: [WanderlodgeForum] Re: Entry door weather seal
To: WanderlodgeForum@yahoogroups.com
Date: Wednesday, February 10, 2010, 10:55 PM


If there is a source it apparently would have to be one of the old-line BB dealers like Holland or Bleakley.

Consensus seems to be that changing to a bulb-type seal is better than stock - the stock is a bit too thick and requires door slamming to close.

Randy says he uses the double-d channel and separates it to use one side. Since I'm unlikely to be around an HD or Lowes for several months I ordered this one this morning: http://www.amazon. com/gp/product/ B000HE7YQM

On 2/11/2010 at 3:22 AM Eric wrote:

>This looks like the same cross section that my door is sealed with. I
>need to replace mine at this time. I sure would be interested if you find
>a source.
>
>Eric Perplies
>96 PT-42

Quote this message in a reply
02-15-2010, 08:11
Post: #8
Entry door weather seal
A final report on the door weatherseal:

After putting a new bushing (bought locally, but this is the same Help 38424:
http://www.fixthisride.com/showproductde...d_id=87524 ) on the door
striker bolt and moving the bolt as far inward as possible while still getting a
good, relatively easy, latch, the
http://www.amazon.com/gp/product/B000HE7...ss_product d-profile
weatherstrip used on the long edge pulled in tight enough to make a good seal.

I was not satisfied with the seal at the top or bottom, so I salvaged enough
good pieces of the original to do both. A complete piece taken from the long
edge for the top, and a single-splice piece for the bottom. The original
adhesive was double-sided foam tape, which was not difficult to remove from the
rubber and then use a new piece of the same.

I did not contact any of the old-line Wanderlodge dealers to see if they have
any of the original seal or not. Someone suggested that Holland in San Diego
might, and Stephen Birtles thought Bleakley might. If anyone does find some
there are are probably several here who would like to know who, and how much it
cost.

This is a link to a picture of the cross-section, as a supplement to my original
line drawing. http://www.arcatapet.net/image/weatherstrip.jpg

Don Bradner
90 PT40 "Blue Thunder"
My location: http://www.bbirdmaps.com/user2.cfm?user=1
Quote this message in a reply
02-15-2010, 11:57
Post: #9
Entry door weather seal

Hi Don
Perfect post on your weatherstrip project............................
I sure wish you were my neighbor!!...................................
I may have some of that weatherstripping that was the Original stuff soon,but I want to be certain it is right before offering it.
Fred & Jeanne Hulse
Morristown Arizona
1997 Wanderlodge WLWB41
Quote this message in a reply
02-15-2010, 13:31
Post: #10
Entry door weather seal
Great! Let me know if/when you get it.

On 2/15/2010 at 4:57 PM Fred Hulse wrote:

>Hi Don
>Perfect post on your weatherstrip project............................
>I sure wish you were my neighbor!!...................................
>I may have some of that weatherstripping that was the Original stuff
>soon,but I want to be certain it is right before offering it.
>Fred & Jeanne Hulse
>Morristown Arizona
>1997 Wanderlodge WLWB41
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)