Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
HELP - 8V92 will not start
06-18-2008, 15:58
Post: #8
HELP - 8V92 will not start
You have air in the fuel lines. Check the fuel level in each of your
filters. Make sure they are full, then try to start. You may have to
add fuel to the filters several times to get it to run. You have
probably added more air trying to start. Once running, you need to
find the sourse of air leaking into a fuel line or filter. Check the
Racor for bubbles while running. If they are present, it could be a
loose or faulty drain fitting. If no bubbles, then the source of the
leak is somewhere else. Racor leak is common.

R.E. (Ron) Marabito, Dallas, TX 92WB40
Currently in Streetsboro, Ohio

--- In WanderlodgeForum@yahoogroups.com, "Larry Kehler"
wrote:
>
> I need some suggestions.
> I have been working on the coach for week but did not start the engine.
> I changed the themostate and checked the water pump on the generator
> engine.
> The generator now runs great.
> Yesterday I put new exhaust manifold gaskets on the street side of the
> coach engine.
> This morning I tried to start the engine to check the exhaust for leaks.
> The engine starts and runs for about 10 seconds and quits. High idle
> switch does not change result. Accelerator pedal has no effect.
> Check engine light does not stay on and the codes are the same as were
> there when I got the coach last year.
>
> My concern is that last week I tried to install a VMSpc JIB on the
> wrong plug and then after help from Rob, installed the JIB on right
> plug. It turned out the JIB was faulty. I am waiting for a
> replacement JIB. The concern is that that messing with the plugs has
> screwed up my ECM and that is causing the non-starting problem.
>
> The engine was running great about three weeks ago before I did all
> the above work. It could be plugged fuel filters. I am planning on
> changing filters tomorrow. It seems unlikely that it is plugged
> filter. My vaccuum gage does not move above low range when it is
> trying to run. Oil pressure moves to 40 lbs. Coolant level is full.
>
> I am real trouble because my wife was planning on leaving tomorrow on
> a two week trip.
> Any suggestions?
> How could I determine if I messed up the ECM?
>
> Larry Kehler
> 1994 PT-40WBDA
> St Louis
>
Quote this message in a reply
Post Reply 


Messages In This Thread
HELP - 8V92 will not start - Larry Kehler - 06-18-2008, 12:45
HELP - 8V92 will not start - Leroy Eckert - 06-18-2008, 13:36
HELP - 8V92 will not start - Mike McMahan - 06-18-2008, 13:46
HELP - 8V92 will not start - Larry Kehler - 06-18-2008, 15:02
HELP - 8V92 will not start - Troy Tikalsky - 06-18-2008, 15:43
HELP - 8V92 will not start - Curt Sprenger - 06-18-2008, 15:46
HELP - 8V92 will not start - Mike McMahan - 06-18-2008, 15:57
HELP - 8V92 will not start - ronmarabito2002 - 06-18-2008 15:58
HELP - 8V92 will not start - Leroy Eckert - 06-18-2008, 16:01
HELP - 8V92 will not start - Gregory OConnor - 06-19-2008, 00:31
HELP - 8V92 will not start - Chuck Wheeler - 06-19-2008, 03:02
HELP - 8V92 will not start - Larry Kehler - 06-19-2008, 07:21
HELP - 8V92 will not start - Curt Sprenger - 06-19-2008, 07:55
HELP - 8V92 will not start - putneyflash@... - 06-19-2008, 08:00
HELP - 8V92 will not start - Leroy Eckert - 06-19-2008, 08:45
HELP - 8V92 will not start - ronmarabito2002 - 06-19-2008, 09:03
HELP - 8V92 will not start - Larry Kehler - 06-20-2008, 11:52
HELP - 8V92 will not start - ronmarabito2002 - 06-20-2008, 12:01
HELP - 8V92 will not start - Dan Williams - 06-20-2008, 13:24
HELP - 8V92 will not start - Curt Sprenger - 06-20-2008, 16:24
HELP - 8V92 will not start - Ryan Wright - 06-20-2008, 19:40
HELP - 8V92 will not start - Larry Kehler - 06-22-2008, 14:51
HELP - 8V92 will not start - Gregory OConnor - 06-22-2008, 15:17
HELP - 8V92 will not start - putneyflash@... - 06-23-2008, 00:17
HELP - 8V92 will not start - Gregory OConnor - 06-23-2008, 03:10



User(s) browsing this thread: 1 Guest(s)