Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Door repairs
06-13-2008, 04:42
Post: #20
Door repairs

What makes noise on my side windows are the screens - they rattle

over bumps. I found that Penisula Glass put a plastic channel at the

base of my screens that slides in another extruded channel in the

window frame. The plastic piece is a few inches shorter than the window

frame. It's purpose is to cinch the screen into the extruded window

frame to prevent rattling. It works. If you don't have such an item,

you can probably get it from Peninsula. It's a simple matter to pop

out the screen, seat the plastic channel, and re-insert the screen.



David Brady,

'02 LXi, NC



Pete Masterson wrote:


I actually only replaced the outside edge, top and bottom but not
the hinge-edge of the weather stripping. The hinge edge was more
bother, so I put it off. I then noticed that the wind noise I was
getting had gone away.


I also got rid of some wind noises in the door window by
installing some weather stripping there, too. I used a kind of 'fur'
stuff -- stiff fibers about 1/16" long that stick up from a 3/16"
sticky tape.

I have a bit of similar wind noise from the driver's side window
as well. Installing a bunch more of the fur-stuff is on my to do list. 

These kinds of things are endless -- I have several of the other
windows that need troubleshooting for rattles and wind noise as well.
Difficulty there is that it helps to be able to sit/stand near the
window and experiment to find exactly where the noise/air leak is
coming from. I can't do that while I'm driving. Wife won't drive the
bus. So I need to wait for a day when there's gale force winds blowing
so I can fiddle with the windows while parked... (We don't get many of
those days around here.)


Pete Masterson
'95 Blue Bird Wanderlodge WBDA 42
El Sobrante CA
"aeonix1@mac.com"






On Jun 13, 2008, at 6:46 AM, Gregory OConnor wrote:


The most annoying noise resulting from wind at the entry door
comes 
from atop the passanger seat. 1- opening up the airvent
pressurizes 
the cab enough to keep air from entering.(close rear windows
also) 2-
Saying "What,,, What,,,, What,,," is effective in reduction of
seat 
noise.  I don't
get the 'skin the cat anology' but these are two of 
those other ways.

Less weather strip is needed at the hinge side.  too much will lift 
the hinge and soon distort. 
hollow strips seem to seal better with 
less pressure but when you distort the mechanics, you end up
needing 
newspaper sticking out the jam. 
GregoryO'Connor
94ptRomolandCa

 --- In "WanderlodgeForum@yahoogroups.com",
David Brady "dmb993@..." 
wrote:

Yes, that piano hinge doesn't help. It was okay on a school
bus
(with 2 doors meeting in the center), but it's not quite good 
enough
on a single door motorhome. What we need is a true automotive
style door hinge, which pulls the door out away from the
vehicle
rather than a piano hinge which severely pinches the weather 
stripping
adjacent to the hinge. Alas, we're probably stuck with it.

David
'02 LXi, NC

Pete Masterson wrote:

I've examined the door geometry very closely. It doesn't
seem 
like 
there's any real solution -- it appears to be a "feature"
(as in 
"that's not a bug, it's an undocumented feature")... When
my 
weather 
stripping was failing, the door was easier to close, but
then 
there 
were some air leaks and wind noise. Once I renewed the
weather 
strip 
(with a profile that was quite similar to the original)
then the 
door 
was a bit harder to close, but the air leaks and wind
noise was 
gone. 


I've adjusted to it and have become accustomed to using a
firm 
hand 
when closing the door. It's not really an excessive amount
of 
force, 
but it is rather more than is required for most vehicles. I 
chalk it 
up to being a Blue Bird quirk.

Pete Masterson
'95 Blue Bird Wanderlodge WBDA 42
El Sobrante CA
aeonix1@... <"aeonix1"@...>



On Jun 12, 2008, at 6:48 PM, brad barton wrote:

Pete, 
That is exactly what happens on mine.  Very frustrating.  Also 
no 
real way that anyone knows of to adjust it.

Brad Barton 00LXiDFW bbartonwx@... <"bbartonwx"@...>


    ------------------------------------------------------------
------------
    To: "WanderlodgeForum@yahoogroups.com"
    <"WanderlodgeForum@yahoogroups.com">
    From:
aeonix1@... <"aeonix1"@...>
    Date:
Thu, 12 Jun 2008 09:56:22 -0700
    Subject:
Re: [WanderlodgeForum] Re: Door repairs

    I'll
note that the door on my coach must be shut with 
authority
    (like
you mean it) or the automotive-type lock won't latch
    properly.
This was the situation with the original weather
    stripping
and with the weather stripping I installed. Once 
the
    automotive
latch is properly activated, then the dead bolt 
lines
    up
properly. 

    If you
try to open the door with the dead bolt locked, then 
when
    the
automotive latch releases, the pressure on the dead 
bolt is
    sufficient
that the solenoid won't move it. Depending on 
which
    side of
the door you're on, you either have to pull or push 
on
    the door
to relieve the pressure on the dead bolt, then the
    solenoid
will through the bolt.

    Pete
Masterson
    '95 Blue
Bird Wanderlodge WBDA 42
    El
Sobrante CA
    aeonix1@...
<"aeonix1"@...>



    On Jun
11, 2008, at 8:22 PM, Gregory OConnor wrote:

        Ryan,
when I use the keyless on my '94 I have to push 
on the
        door
to 
        line
up the deadbolt. This is all done blind folded as 
I cant
        see
or 
        feel
what is going on in the jamb.  I
think someone 
replaced the 
        seal
with a too ambitious foam/rubber  product.
fat 
seals endup 
        causing
the door operator to slam and place a hard turn 
on the 
        lock.  One other issue is that the
door on my 94 is 
alumnium and 
        swells
more than the steel frame in the sun. just some 
things to 
        consider
with your project



----------------------------------------------------------------
--------
Instantly invite friends from Facebook and other social 
networks to 
join you on Windows Live™ Messenger. Invite friends now! 
source=TXT_EML_WLH_InviteFriends>


-----------------------------------------------------------------
-------

No virus found in this incoming message.
Checked by AVG. 
Version: 7.5.524 / Virus Database: 270.3.0/1500 - Release
Date: 
6/12/2008 4:58 PM





------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:

<*> Your email settings:
    Individual
Email | Traditional

<*> To change settings online go to:
    (Yahoo! ID
required)

<*> To change settings via email:
    "WanderlodgeForum-digest@yahoogroups.com" 
    "WanderlodgeForum-fullfeatured@yahoogroups.com"

<*> To unsubscribe from this group, send an email to:
    "WanderlodgeForum-unsubscribe@yahoogroups.com"

<*> Your use of Yahoo! Groups is subject to:





No virus found in this incoming message.
Checked by AVG. Version: 7.5.524 / Virus Database: 270.3.0/1500 - Release Date: 6/12/2008 4:58 PM
Quote this message in a reply
Post Reply 


Messages In This Thread
Door repairs - Ryan Wright - 06-10-2008, 12:54
Door repairs - Curt Sprenger - 06-10-2008, 13:20
Door repairs - Leroy Eckert - 06-10-2008, 13:20
Door repairs - Pete Masterson - 06-10-2008, 13:33
Door repairs - Rob Robinson - 06-10-2008, 13:41
Door repairs - Paul Carver - 06-10-2008, 17:23
Door repairs - Ryan Wright - 06-11-2008, 10:24
Door repairs - Gregory OConnor - 06-11-2008, 15:22
Door repairs - brad barton - 06-12-2008, 03:39
Door repairs - Pete Masterson - 06-12-2008, 04:56
Door repairs - bumpersbird - 06-12-2008, 07:09
Door repairs - brad barton - 06-12-2008, 13:48
Door repairs - George Burke - 06-12-2008, 14:41
Door repairs - Pete Masterson - 06-13-2008, 00:33
Door repairs - Gregory OConnor - 06-13-2008, 01:46
Door repairs - David Brady - 06-13-2008, 02:30
Door repairs - David Brady - 06-13-2008, 02:53
Door repairs - Pete Masterson - 06-13-2008, 03:29
Door repairs - Pete Masterson - 06-13-2008, 03:53
Door repairs - David Brady - 06-13-2008 04:42
Door repairs - Pete Masterson - 06-13-2008, 04:58
Door repairs - David Brady - 06-13-2008, 05:10
Door repairs - Ryan Wright - 06-13-2008, 08:08
Door repairs - Leroy Eckert - 06-13-2008, 10:56
Door repairs - Jack and Liz Pearce - 06-13-2008, 11:03
Door repairs - Pete Masterson - 06-13-2008, 13:16
Door repairs - Pete Masterson - 06-13-2008, 13:18
Door repairs - David Brady - 06-13-2008, 13:31
Door repairs - Don Bradner - 06-13-2008, 13:40
Door repairs - David Brady - 06-13-2008, 15:11
Door repairs - Pete Masterson - 06-14-2008, 10:30
Door repairs - Ryan Wright - 06-14-2008, 14:54



User(s) browsing this thread: 1 Guest(s)