HWH Jack Actuator 100 Series
|
11-13-2006, 09:17
Post: #1
|
|||
|
|||
HWH Jack Actuator 100 Series
Stephen, I had to replace an actuator on my coach. I remember that with help-
Bim Burt- it took 2 of us to get that thing aligned on the main cylinder. There are 2 ports on the cylinder that the actuator has to align to-- and the original bands that hold the actuator on that cylinder do not give you any room to align it easily. We went out and bought some worm drive large hose clamps and used those to align it and tighten it so the original clamps could be used. I did not, at the time try and rebuild the actuator- probably just O-rings. Ernie Ekberg 83 PT40 Livingston, Montana [Non-text portions of this message have been removed] |
|||
11-13-2006, 13:27
Post: #2
|
|||
|
|||
HWH Jack Actuator 100 Series
Hello everyone! Im needing help with my jacks on the bus... Seems one
of the rear 9000# jacks wont go completely down, due to a faulty actuator. The actuator gets stuck about 3/4 out and bogs the motor down, therefore will not push jack completely vertical, and allow the fluid to pass to lift the jack to raise it. The other ones have freed themselves up well and work good. I was hoping in time, this one might free itself--but after many tries, it just goes out the same amount each time. The actuator rod does not seem bent. Just had the pump motor rebulit, and installed a 150A Thermal breaker (just in case). Anyone have one/or a spare jack lying around for parts? I believe HWH wants $180.00 or so for a new one. Trying to repair this one, or find a part to repair first. Any thoughts? Thank you, Stephen H 81 FC-33SB Plant city, FL |
|||
11-13-2006, 15:23
Post: #3
|
|||
|
|||
HWH Jack Actuator 100 Series
I will give HWH a call and see what they say. I can bet they will want to
sell a new actuator!! I may not have a choice.. Maybe could get a o'ring kit from them.. I will find out tomorrow. Thanks for the great info!!! Stephen _____ From: WanderlodgeForum@yahoogroups.com [mailto:WanderlodgeForum@yahoogroups.com] On Behalf Of erniecarpet@... Sent: Monday, November 13, 2006 9:17 PM To: WanderlodgeForum@yahoogroups.com Subject: Re: [WanderlodgeForum] HWH Jack Actuator 100 Series Stephen, I had to replace an actuator on my coach. I remember that with help- Bim Burt- it took 2 of us to get that thing aligned on the main cylinder. There are 2 ports on the cylinder that the actuator has to align to-- and the original bands that hold the actuator on that cylinder do not give you any room to align it easily. We went out and bought some worm drive large hose clamps and used those to align it and tighten it so the original clamps could be used. I did not, at the time try and rebuild the actuator- probably just O-rings. Ernie Ekberg 83 PT40 Livingston, Montana [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)