94pt 'cool o matic' gally exhaust fan

[Ron Hazlett]

If anyone has removed their cool-o-matic Fan cover and has no use for
it. I would be happy to purchase it from them! Mine was damaged by a
falling tree branch.

Ron Hazlett
1987 FC The Hideaway
Ron.hazlett@...


--- In WanderlodgeForum@yahoogroups.com, "Joyce and Richard Hayden"
wrote:
>
> Pete,
> I, like Curt, removed the cool-o-matic unit and replaced with a
Fantastic. The motor with blade and grille are good and you may have
them for the shipping if you like. If interested let me know soon as
we are heading to our winter quarters near the middle of Oct.
>
> Dick Hayden - '87 PT 38 - Lake Stevens, WA
> ----- Original Message -----
> From: Pete Masterson
> To:
WanderlodgeForum@yahoogroups.com om>
> Sent: Tuesday, September 30, 2008 9:48 AM
> Subject: Re: [WanderlodgeForum] 94pt 'cool o matic' gally exhaust
fan
>
>
> The Fantastic Fan as a replacement makes sense ... but I like the
> cool-o-matic because it allows me to run the fan (and get
> ventilation) even if its raining.
>
> Does anyone have info about "Maxxaire" or other alternatives that
> might allow all-weather use of the fan?
>
> Note, my cool-o-matic quit a few days ago. I'm not sure if it's
the
> thermostat or the fan itself -- or a fuse (anybody know where the
> fuse is?). (I don't know when I'll have time to do a full trouble-

> shooting on the fan while we're on the road...)
>
> Pete Masterson
> '95 Blue Bird Wanderlodge WBDA 42
> aeonix1@...
> On the road near Scranton, PA
>
> On Sep 30, 2008, at 11:25 AM, Curt Sprenger wrote:
>
> > Greg,
> >
> > Replace the cool-0-matic with an Fantastic Fan, the rain
sensor, 3
> > speed, in/out. Wire it to the same cool-O-matic thermostat
wires.
> > You'll have a new fan and more light in the kitchen.
> >
> > On Tue, Sep 30, 2008 at 7:55 AM, Gregory OConnor
> > > wrote:
> > My center exhaust fan is a 12 volt roof mount exhaust. I keep it
> > running on a wall mounted thermostat(as designed) set at 90degF
> > with a window open and a cheap home style heater duct filter in
the
> > window. works good, the filter gets choked with dust that would
> > otherwise settle in the parked bus or fan blades and motor
(should
> > have a window open at each end but am too lazy).
> >
> > I took the fan housing apart to clean and lube a noisy bearing
and
> > uncovered a stowed three speed switch under the fan. the switch
says
> > potentiometer and has two springs at back which I believe are
heat
> > sinks (they get hot). I would like to have access to the switch
to
> > reduce the speed while drycamping (layoff Leroy) and conserve
> > battery. I also like the idea of a slower moving fan while
stored
> > and unattended and a higher speed fan while cooking.
> >
> > I was thinking of hard wireing around the switch and moving the
> > potentiometer/switch to the wall near the thermostat . if you
have
> > the switch where the fan mfg designed (thru a hole in the
cover) you
> > cant slid in the headliner blank. Prob with moving the switch is
> > the "heat sink" in the wall???? I dont even know if the
thermostat
> > has a wire 'to the fan' or 'to a relay - to the fan'??? also of
> > concern is the need for a heat sink?? does a product that
produce
> > heat (pot switch),not consume energy?? would a rheostat be a
better
> > choice for the wall??? gotta learn more about potentiometer vs
> > rheostat, both cool words but must be more to their differences.
> >
> > Greg94ptCa
> >
> >
> >
> >
> >
> > --
> > Curt Sprenger
> > 1987 PT38 8V92 "MacAttack Racing"
> > Anaheim Hills, CA
> >
>