Wanderlodge Gurus - The Member Funded Wanderlodge Forum / Discussions / Generator v / First newbee mistake w/ generator on SpongeBob

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
First newbee mistake w/ generator on SpongeBob
10-26-2014, 21:00 (This post was last modified: 10-27-2014 13:43 by travelite.)
Post: #4
davidbrady Offline
Grand Master Guru
*****
 		Posts: 2,025
Likes Given: 268
Likes Received: 212 in 161 posts
Joined: Feb 2013
Reputation: 17
RE: First newbee mistake w/ generator on SpongeBob
This past Friday I had a chance to give my MatJack 1 a try. I disconnected the fuel pump and tied it out of the way; I removed the air hoses and air fittings from the top of the air springs; I then removed the two top bolts releasing the air springs from the engine support mounts. I plumbed the MatJack 1 with air via a pressure regulator and slowly lifted the front of the Kubota. I then packed cribbing between the engine mounts and the air springs for support. This gave me enough room to reach around the backside of the kubota to release all the sump pan bolts. After unbolting the oil pump strainer the sump came right out:

QUIZ: Where are the main bearing caps?

İmage İmage İmage İmage İmage
david brady,
'02 Wanderlodge LXi 'Smokey' (Sold),
'04 Prevost H3 Vantare 'SpongeBob'

"I don't like being wrong, but I really hate being right"
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 


Messages In This Thread
RE: First newbee mistake w/ generator on SpongeBob - davidbrady - 10-26-2014 21:00



User(s) browsing this thread: 1 Guest(s)

Contact Us | Wanderlodge Gurus - Free Classifieds & Support Forum Community Service | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication