90 40WB Will Not Crank Over

[randydupree2000]

--- In WanderlodgeForum@yahoogroups.com, "joedana0502"
wrote:
>the switch in the back has been know to go bad.i have squirted wd-
40 into the switch and fixed a bad switch.
randy
> I'm not sure why but the engine did start from the switch in the
back.
> I am sure I tried it before, anyway it starts from the back. Still
> nothing from the front ignition switch. When it started I also
> received an engine Alert CIS Signal Voltage High. Not sure what
that
> means are if that is part of the problem. I am going to buy a
signal
> tracer tester so I can trace out the wires. I can't see where the
> wires go and I do not have a set of plans.
>
> Joe Blankenship
> 90 40WB
> Phoenix, AZ
>
> --- In WanderlodgeForum@yahoogroups.com, "Gregory OConnor"
> wrote:
> >
> > Joe, If you turn the ig. in the bus to 'on' (one click
clockwise) the
> > shift selector will light up. If you go in the engine
compartment to
> > start you must first flip a toggle in the engine compartment
to 'rear'
> > (That toggle has a center position that will disable both
switches),
> > turning the engine compartment ig. key to 'on' will only light
the
> > shift selector in the bus. the dash will notlight up. If none
of this
> > works, I would hold the 'AUX.'switch on the dash that combines
all the
> > batteries to one loop and try to start. I think if you try wat
Mike
> > and Curt said, you have weak batteries and starting on weak
batteries
> > is a sure way to burn a starter.
> > Gregory O'Connor
> > hungover and 10 lbs fatter
> >
>