Probably an easy question for most
|
01-22-2006, 04:09
Post: #6
|
|||
|
|||
Probably an easy question for most
--- In WanderlodgeForum@yahoogroups.com, "moolah_85224" <moolah@m...>
wrote: > > --- In WanderlodgeForum@yahoogroups.com, "William Jensen" > > > > > On my coach there is a silver, flat metal bar that is screwed onto > > the side wall of the grey water tank compartment. The compartment > > that has your valve opening controls. At the end of the bar, there > > is a 90 degree angle, the about another 2" length and a half moon > > cut-out at the end. You use this to Pry up the stuck valve. If > > you don't have one, then as George said, use a big screwdriver. > > Air up your coach, and open the valve switch. Gentle prying will > > open the valve. > > > > Once open, you need to lubricate it up. And it doesn't help just to > > spray lubricant on the shaft. And don't do that!!! That is not > > where it sticks. If you go to the wanderlodge owners online site, I > > have a excellent pictorial on how to remove and replace, or just > > lubricate the valves. It is under the article section, sub-category > > repair and maintenance. You may need new valve paddles, and those > > can be purchased from Jeff Miller at the Dupree site that John > > listed. > > > > good luck > > > > William Jensen > > 1993 PT40 WBWL > > Deerfield Beach, FL > > > > Thanks to you both. Can you give me a link to the Wanderlodge owneres > online site? > Forgot, Tom Merriman Chandler, AZ |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Probably an easy question for most - moolah_85224 - 01-21-2006, 12:53
Probably an easy question for most - George Lowry - 01-21-2006, 16:21
Probably an easy question for most - John - 01-21-2006, 23:07
Probably an easy question for most - William Jensen - 01-22-2006, 03:46
Probably an easy question for most - moolah_85224 - 01-22-2006, 03:58
Probably an easy question for most - moolah_85224 - 01-22-2006 04:09
Probably an easy question for most - William Jensen - 01-22-2006, 14:11
|
User(s) browsing this thread: 2 Guest(s)