Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LXi, Three Receiver Hitch
11-22-2013, 21:08
Post: #16
RE: LXi, Three Receiver Hitch
Al,

All that steel back there is 3/8 inches thick. The upside down C-channel that holds the three receivers is 3/8" thick steel, 7.5" wide with 3" flanges; the upright L-sections connecting the receiver bar to the frame rails are 3/8" thick, 8" wide with a single 3" flange (way better than plates). The twin bars that run forward to the front of the engine are 2" by 2", I'm not sure about wall thickness. Just some info to relay to Overbilt. Like I said, it's a 10,000 lb capacity hitch with a maximum tongue weight of 1000 lbs.

david brady,
'02 Wanderlodge LXi 'Smokey' (Sold),
'04 Prevost H3 Vantare 'SpongeBob'

"I don't like being wrong, but I really hate being right"
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 


Messages In This Thread
RE: LXi, Three Receiver Hitch - davidbrady - 11-22-2013 21:08



User(s) browsing this thread: 1 Guest(s)