Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Belts & propane furnace
10-17-2010, 15:39
Post: #2
Belts & propane furnace
I don't think there is a good way to tighten the belts without swinging the rad.  Keep a good check on you belts as if you have any trouble on the road it can cost you a lot more than in your driveway or local shop. Don't ask me how I know that/////   Four bolts in the bumper & two in the rad. It is not bad to swing the rad. I do mine at least once a year.  If you want give me your phone number & I'll give you a call.        Don                      


On Sun, Oct 17, 2010 at 10:40 AM, williamcharrison <"williamcharrison@yahoo.com"> wrote:
 


Is there any way to tighten engine belts without removing

the back bumper to swing the radiator out on my 90 SP36?



Also, just returned from a chilly trip where only the front propane

furnace worked. The rear elec heater and rear propane furnace do

not although the elec heater in the bathroom does. The schematic

I have refers to a Primus furnace but I don't have a Primus.



William C Harrison

Akron, Ohio

90 WLSP36



Quote this message in a reply
Post Reply 


Messages In This Thread
Belts & propane furnace - williamcharrison - 10-17-2010, 02:40
Belts & propane furnace - Donald Spithaler - 10-17-2010 15:39



User(s) browsing this thread: 1 Guest(s)