87 FC 35 Generator??????

[richardgideon]

Bob, disconnect the white 7 pin connector on the backside of the DC control box
near top (the left control box on the DKD Onan).

Clean the pins and use a magnifying glass and check for burnt pins or bent and
misaligned pins. If necessary 'jump around' the burnt pin using the correct
guage wire and a butt connector or one of your choice. Put dielectric grease on
the connector and reassemble and ensure the connector snaps in place (may even
try a little super glue to keep connector from jiggling loose.

Dick Gideon
1989 FC35
ONAN DKD
Rolla, MO
573.465.0527

--- In WanderlodgeForum@yahoogroups.com, "bob_maloney@..."
wrote:
>
> I have a 87 FC 35 and the generator will not start from any starting console.
The generator is an Onan 8.0 diesel I took the starter off and had it checked,
checked out great. I put the starter back on and it still will not start. I
then short the solenoid wire to the battery and it would start if was getting
the signal from the console. I have since taken apart the console on the
generator itself to find the Ford style starter solenoid inside and checked it
out and it works fine. The ground side of the solenoid at this point seems to
be getting the wrong signal as it should be grounding and in fact has 12 volts
to it. The switch side of the solenoid at this point has a little over 8 volts
when the starter switch is activated. The generator attempts to start as it
should operating the fuel shutoff and finally for lack of a better word times
out and either trips the DC output control or the push to reset circuit breaker.
From this can someone either tell me what to look for or if at all possible
supply me with a schematic. Any help is greatly appreciated.
> Thanks in advance,
> Bob Maloney
> Clay City KY
>