M380 Bedroom Slide Won't Retract

[garyvant55439]

Pete,

Thanks. I understand the LED is an indicator - as the map is not the country,
it is not the problem. Just wondered if someone else had encountered this and
how they fixed it. In the meantime, I'm chasing throught the electrical system
with my Fluke.

Regards,

Gary Van Tassel

--- In WanderlodgeForum@yahoogroups.com, Pete Masterson wrote:
>
> The most common problem is a poor ground.
>
> THe system undoubtedly works through a relay (located in one of the
> power centers), so it may be the ground for the relay or possibly, the
> relay itself has gone bad (the contacts tend to get burnt and/or
> corrode over time).
>
> Time to get out the multi-meter and start checking circuits.
>
> The LED is a symptom, but not the reason for the problem.
>
> Pete Masterson
> '95 Blue Bird Wanderlodge WBDA 42
> El Sobrante CA
> aeonix1@...
>
>
>
> On May 1, 2009, at 9:48 AM, garyvant55439 wrote:
>
> > Help!
> >
> > After years of perfect operation, my bedroom slide decided not to
> > retract. The problem appears to be that it does not detect that the
> > ignition switch is in the "Accessory" position, because that LED on
> > the control panel does not light up.
> >
> > Any ideas appreciated.
> >
> > Gary Van Tassel
> > 2004 M380
>