HELP - 8V92 will not start

[putneyflash@...]

take off one end of the outlet line from the secondary filer you should get a flow when you crank. You can also drop the inlet line into a small container of fuel and by-pass to see if she fires. also hold throttle open, if air is low she is trying to start at idle.

--
RE

-------------- Original message from "Larry Kehler" : --------------

Thanks for all the suggestions.
I replaced both filters.
The Racor was low about 1.5 inches.
The Secondary was low about .5 inch.
I refilled both to top and cranked 10 seconds.
This time it did not start or fire at all.
After three tries, I opened both filters again and the
Racor was full. The secondary was down maybe .25 inch.
Refilled and cranked three more times, no fire.
Looked at secondary and it appeared full.

My questions now are, is there another way to build the prime?
Could it be a fuel pump problem? If so how do you test the pump?

Larry Kehler
1994 PT-40 WBDA
St Louis

--- In "WanderlodgeForum%40yahoogroups.com", "ronmarabito2002"
...> wrote:
>
> You have air in the fuel lines. Check the fuel level in each of your
> filters. Make sure they are full, then try to start. You may have to
> add fuel to the filters several times to get it to run. You have
> probably added more air trying to start. Once running, you need to
> find the sourse of air leaking into a fuel line or filter. Check the
> Racor for bubbles while running. If they are present, it could be a
> loose or faulty drain fitting. If no bubbles, then the source of the
> leak is somewhere else. Racor leak is common.
>
> R.E. (Ron) Marabito, Dallas, TX 92WB40
> Currently in Streetsboro, Ohio