Toilet emergency...Help!

[Scott Forman]

Well, short of driving to Memphis to do it for me, I'd say that's
about the most complete answer I could get...Thanks!

Scott

--- In WanderlodgeForum@yahoogroups.com, "Ralph L. Fullenwider"
wrote:
>
> Hi Scott:
>
> Your going to need a ball valve replacement package. If your
commode is the
> original and is the starlight or galaxy, the part number is #09868
and
> there should be the needed replacement instructions.
>
> But a couple of short cuts might help. 1. Turn off the water and
look where
> the water hooks up to the ball valve and un screw the nut holding
the tube
> to the valve. 2. Open the top lids and on your left as you face the
front
> of the unit you will see a circle plastic piece that is flush, with
a small
> knife blade pry it up and out but take care not to bang it up too
much.
>
> Now then there are 2 screws with nuts that hold the unit to the
floor and
> with a flash light peer down the hold of the cover you just
removed, I use
> a 3/8 drive 18 inch extension, a swivel and a deep well socket to
loosen
> and remove that nut. Then with a long stout screw driver, press
down on the
> foot pedal and use the long stout screwdriver to hold it down, now
you can
> see the second nut that must be removed. The commode is now up and
out the
> door to work on, oh, grab a beer on the way by the refer.
>
> You are going to have to remove the flush mechanism to replace the
ball
> valve and should find some 8 or so screws around the base holding
the flush
> mech to the bowl, there are also 2 hoses held on by crimp hose
clamps that
> must be removed. Now the base is off and you can see where you have
to go.
> Whole job should take you about 1 hr 15 minutes or so from out to
in and done.
>
> Safe travels,
>
> Ralph and Charolette Fullenwider
> 84FC35
> Duncan, Oklahoma
>
> At 01:01 AM 9/2/2007 +0000, you wrote:
> >Mine has a cut-off, thankfully.
> >
> >Still need to know how to fix it.
> >
> >Scott
> >
>