Wandersound Stereo Interference

[jwasnewski]

I recently completed the installation of new rear and side cameras.
They work well even at night. I used the same on/off switch and
constant voltage power supply as the old camera system. All wiring
after the power supply is new 20 gauge wire fused with 2amp fast blow
CMA(??) type from Radio Shack as per instuctions.. I installed two 3.5
LCD monitors using the same video cable as the old camera on the rear
camera. I used the cable that came with the side camera, 4 conductor S
Video. I noticed this morning that my Wandersound stereo signal gets
knocked off line with ensuing static when I turn on the cameras.
Any frequency guru's out there? Any ideas? The TV's are not affected.
No interference before the retrofit. I did not see any capacitors???in
the power lines of the old system.

Leroy Eckert
1990 WB-40"Smoke N Mirrors"
Niceville, FL
At Salt Springs Resort, Ocala National Forest