Thinking caps on?

[one_dusty_hoot]

Hi Ralph,
Sometimes my thinking cap is too small won't fit!

I would start at the source since you can't find
any apparent leaks, cap or shut off the pump with
a valve, then if it don't "burp" you have a starting
point.

Still burping, problem at the pump.
No burping, isolate connections, go from there.

bob janes, greenville, sc

--- In WanderlodgeForum@yahoogroups.com, "Ralph L. Fullenwider"
wrote:
>
> Morning George:
>
> Perhaps on the set point, but they come preset and have not looked
to see
> if there is a set screw to change that. Since you had problems with
the
> check valve (anti leak down valve) then I won't introduce one into
this system.
>
> Thank you
>
> Safe travels,
>
> Ralph and Charolette Fullenwider
> 84FC35
> Ralph's RV Solutions, Duncan, Oklahoma
>
> At 07:42 AM 2/22/2007 -0500, you wrote:
> >Hello Ralph, just guessing here, but my house system cuts off at
50 psi. I
> >don,t know anything about rv systems, but could your cut out
pressure be
> >set a little high,(65 psi), causing expansion/contraction within
the
> >system. Another possibility, I put a new pump in several yrs.ago,
(house),
> >and the mfg.recommended installing a anti leak down valve with
their pump,
> >(didn't have one previously). Long story short, had problems until
a
> >plumber friend told me to take that valve out, that it wasn't
needed.
> >Immediately solved the problem, which was like yours, pump
recycling. Hope
> >one of these suggestions help, George Burke 77FC31SB Charlotte
> > ----- Original Message -----
> > From: Tom Meservey
> > To: WanderlodgeForum@yahoogroups.com
> > Sent: Thursday, February 22, 2007 7:04 AM
> > Subject: [WanderlodgeForum] Re:Thinking caps on?
> >
> >
> > Hi Ralph,
> >
> > I think you are right either the Sporlan valve or some air in
the line
> > that keeps tripping it; but my bet would be the Sporlan valve.
> >
> > Regards.
> >
> > Tom Meservey, USN (Ret)
> > Ladson, SC '81FC33' for sale
> >
>