Thinking caps on?

[Ralph L. Fullenwider]

Morning George:

Perhaps on the set point, but they come preset and have not looked to see
if there is a set screw to change that. Since you had problems with the
check valve (anti leak down valve) then I won't introduce one into this system.

Thank you

Safe travels,

Ralph and Charolette Fullenwider
84FC35
Ralph's RV Solutions, Duncan, Oklahoma

At 07:42 AM 2/22/2007 -0500, you wrote:
>Hello Ralph, just guessing here, but my house system cuts off at 50 psi. I
>don,t know anything about rv systems, but could your cut out pressure be
>set a little high,(65 psi), causing expansion/contraction within the
>system. Another possibility, I put a new pump in several yrs.ago,(house),
>and the mfg.recommended installing a anti leak down valve with their pump,
>(didn't have one previously). Long story short, had problems until a
>plumber friend told me to take that valve out, that it wasn't needed.
>Immediately solved the problem, which was like yours, pump recycling. Hope
>one of these suggestions help, George Burke 77FC31SB Charlotte
> ----- Original Message -----
> From: Tom Meservey
> To: WanderlodgeForum@yahoogroups.com
> Sent: Thursday, February 22, 2007 7:04 AM
> Subject: [WanderlodgeForum] Re:Thinking caps on?
>
>
> Hi Ralph,
>
> I think you are right either the Sporlan valve or some air in the line
> that keeps tripping it; but my bet would be the Sporlan valve.
>
> Regards.
>
> Tom Meservey, USN (Ret)
> Ladson, SC '81FC33' for sale
>