Plumbing gone awry
|
05-16-2005, 07:20
Post: #1
|
|||
|
|||
Plumbing gone awry
My 78FC 31 burst a few pipes over the winter. (A lesson in blowing
out the lines learned the hard way!) At any rate, after much labor installing a new hot water heater and new copper tubing I was thrilled to find the water-especially the hot water--flowing smoothly, but it was a short lived thrill as I soon discovered that the tanks were not filling up. I tried flipping the tank fill switch; there are no leaks, the water is flowing, but not through to the tank fill pipe. Is there an obvious way to check the shut off valve? Any help would be greatly appreciated. John Fitz FC 31 Maynard MA |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: