Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Potential water seeping, and genset overheat 450LXi
09-09-2015, 21:49 (This post was last modified: 09-10-2015 09:46 by dentmac.)
Post: #1
Potential water seeping, and genset overheat 450LXi
Hi, After replacing the rotting bay floors and soaked insulation, I removed the wood on the front bulkhead of bay one, concerned that there was a leak there also. There was no leak, but 2 bolts from the wheel well were showing rust . The curb side well was not sealed and the water wicked in to cause the rust. Only the bolt is not SSteel. The picture showing the bolt locations shows a little of the front tire.
The other catch was just lucky by seeing from a different angle. There are 2 layers of louvers on the generator air intake. The 2nd layer is hard to see and 3 of my fins were closed. My genset is in the front so other 450's may not have that intake. Best to check.
Ross


Attached File(s) Thumbnail(s)
İmage İmage

Ross MacKillop
Wiarton Ontario
2006 450 Lxi
Find all posts by this user
Like Post Quote this message in a reply
09-10-2015, 08:17
Post: #2
RE: Potential water seeping, and genset overheat 450LXi
Ross, was your generator never relocated?

Ernie Ekberg
Prevost Liberty Classic XL
Weatherford, Tx
http://www.ernieekbergflooring.net
Find all posts by this user
Like Post Quote this message in a reply
09-10-2015, 09:44
Post: #3
RE: Potential water seeping, and genset overheat 450LXi
Nope ...It is in the bow on a nice slide out. Heart

Ross MacKillop
Wiarton Ontario
2006 450 Lxi
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)