Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Automatic Transfer Switch
04-16-2018, 00:04
Post: #6
RE: Automatic Transfer Switch
Good catch on the toilet water pressure David. When I rebuilt the air-water sequencer valve and got a bath, I concluded that it didn’t need full open throttle! LOL

Yes, I think everyone with a water manifold like the LXi has should add a shield. I’m beginning to think it’s a condensation issue on the piping as I can’t find any leaks but I have seen a small puddle of water that ran off the new shield after a hot/cold/hot rapid weather change that we have had in Texas this year. Also due to the cold, I left the Aquahot on for a while so it may have added to the weather change issue. In any event, the water goes on the floor now rather than on the switch boxes. The ATS box is not very sophisticated from an electronics basis, but the good news is that failures will probably just affect the gen set transfer but allow shore power in. So that’s good. Now that I have a spare I’ll probably never have another failure anyway!

Mike Bulriss
2001 LXi 43' DS Millennium Edition
San Antonio, TX
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 


Messages In This Thread
Automatic Transfer Switch - mbulriss - 04-13-2018, 00:51
RE: Automatic Transfer Switch - mbulriss - 04-16-2018 00:04



User(s) browsing this thread: 1 Guest(s)