Pete Masterson
01-19-2009, 04:31
Just in case you hadn't thought about it, but when was the last time the air-dryer was serviced. The recommended service interval is 2 years* (perhaps a longer interval is OK for an RV) as thedesiccantdoes lose effectiveness over time.
And, as suggested, only a small bit of water can cause problems throughout the system.
Pete Masterson
'95 Blue Bird Wanderlodge WBDA 42 (For Sale)
El Sobrante CA
"aeonix1@mac.com"
On Jan 19, 2009, at 8:18 AM, pattypape wrote:
IF your location is in a temperature below 32* freeze area,
moisture, & condensation will cause all kinds of strange issues.
there are numerous check valves , pressure reducing,etc valves, with
diaphragms that do not like freezing temps.
Bill 88 FC michigan
--- In "WanderlodgeForum@yahoogroups.com", "t3brian"wrote:
Thank You everybody for your suggestions......A combination of filling the suspension a few times after a shortaround the block drive did the trick!!!!!!However is this a sign of something on its way to a failure???or... is it simply a sign of older parts that every once in awhileneed a little kick start to get going???the bird did 'rest' for 6 months since it's last venture....but she is up and ready to go now...again thank you all for your suggestions...--- In "WanderlodgeForum@yahoogroups.com", "Don Bradner"wrote: Keep in mind that the Front/Rear are brakes, not air bags. Thoseshould peak around 120psi.In mine, the sequence is that the brakes air first, to about 75-90lbs, then the air bags, then the auxiliary items, then the brakesfill the rest of the way. If yours is the same, it sounds likesomething is leaking badly during the air bag fill.Don Bradner90 PT40 "Blue Thunder"Posting today by satellite from QuartzsiteMy location: www.bbirdmaps.com/user2.cfm?user=1On 1/18/2009 at 10:30 PM t3brian wrote:fromHello...All... as always I greatley appreciate any assistance
thegroup...wentI am getting ready to make the journey to the Q-ralley and I
todrive our 84 PT-40 for a quick trip and I cannot get thesuspension tofill....isThe front & rear pressure reads 75 pounds but the tag pressure
zero.....I have filpped both dump switches repeatedly but no change....any suggestions????