02-05-2007, 02:56
Ralph L. Fullenwider
02-05-2007, 04:23
If the regulator has 2 small holes on each side of the water hose
connector, you get a new one from BB, then simply unscrew the center part
out of the existing housing with either needle nose pliers or if large
enough a set of snap ring pliers, se the old parts aside. Remove the new
regulator parts form the new one and install in the original housing. About
a 10 minute job. If not this style then you in for a cramped job getting to
the back of that one via a small space in the same area as the water heater
or just toward the front from there.
Safe travels,
Ralph and Charolette Fullenwider
84FC35
Ralph's RV Solutions, Duncan, Oklahoma
At 02:56 PM 2/5/2007 +0000, you wrote:
>Has anyone replaced a city water regulator on a 89 36SP?
>How to you gain access to the back of the regulator?
>
>
connector, you get a new one from BB, then simply unscrew the center part
out of the existing housing with either needle nose pliers or if large
enough a set of snap ring pliers, se the old parts aside. Remove the new
regulator parts form the new one and install in the original housing. About
a 10 minute job. If not this style then you in for a cramped job getting to
the back of that one via a small space in the same area as the water heater
or just toward the front from there.
Safe travels,
Ralph and Charolette Fullenwider
84FC35
Ralph's RV Solutions, Duncan, Oklahoma
At 02:56 PM 2/5/2007 +0000, you wrote:
>Has anyone replaced a city water regulator on a 89 36SP?
>How to you gain access to the back of the regulator?
>
>