Hi Everyone,
I need to do a little work behind the fan.
Do these locking nuts need to be replaced each time they are removed??
I think they are called crush nuts.
Does anyone know the torque for the fan bolt nuts.
It would not be a pretty picture, if the fan kissed the radiator.
It would make a lot of noise.
Thanks,
Bill 88 FC Michigan
Torque is a spec that is determined by fastener diameter and thread count per
inch. Lock tite and grade 8 bolts will usually keep the fan out of the
radiator. The Cat shop manual has the torque specs.
Mike Hohnstein
Germantown, WI
----- Original Message -----
From: pattypape
To:
WanderlodgeForum@yahoogroups.com
Sent: Monday, April 25, 2005 9:22 PM
Subject: [WanderlodgeForum] Locking Nuts on Fan
Hi Everyone,
I need to do a little work behind the fan.
Do these locking nuts need to be replaced each time they are removed??
I think they are called crush nuts.
Does anyone know the torque for the fan bolt nuts.
It would not be a pretty picture, if the fan kissed the radiator.
It would make a lot of noise.
Thanks,
Bill 88 FC Michigan
------------------------------------------------------------------------------
Yahoo! Groups Links
a.. To visit your group on the web, go to:
http://groups.yahoo.com/group/WanderlodgeForum/
b.. To unsubscribe from this group, send an email to:
WanderlodgeForum-unsubscribe@yahoogroups.com
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]