Curt Sprenger
09-26-2006, 15:10
Eric,
Again I'm posting an answer to you on the wanderlodge sites. Your mail
system rejects everything I send to you.
Eric,
It was a hunting expedition to locate them...ended up finding them
forward of the center console drawers, near or on the floor. I removed
the drawers. Not a lot of room in there to work, so if your inverters
are in the same location, try pulling them toward you without breaking
the wires. Will make it a lot easier to R&R. I mounted the inverters on
the forward wall in that compartment, another PITA job.
Curt Sprenger 1987 PT38 8V92, Anaheim Hills, Calif.
Eric Perplies wrote:
Curt,
I have to replace my Dash EL Inverters. Can you describe how you get
to them. In what area of the lower dash where the inverters located.
How did you get at them? From under the dash? or from removing the
dash and working in the gap?
Eric Perplies
96' 42' WBWL
currently in Ft. Wayne, IN
--
Curt Sprenger 1987 PT38 8V92, Anaheim Hills, Calif.
Again I'm posting an answer to you on the wanderlodge sites. Your mail
system rejects everything I send to you.
Eric,
It was a hunting expedition to locate them...ended up finding them
forward of the center console drawers, near or on the floor. I removed
the drawers. Not a lot of room in there to work, so if your inverters
are in the same location, try pulling them toward you without breaking
the wires. Will make it a lot easier to R&R. I mounted the inverters on
the forward wall in that compartment, another PITA job.
Curt Sprenger 1987 PT38 8V92, Anaheim Hills, Calif.
Eric Perplies wrote:
Curt,
I have to replace my Dash EL Inverters. Can you describe how you get
to them. In what area of the lower dash where the inverters located.
How did you get at them? From under the dash? or from removing the
dash and working in the gap?
Eric Perplies
96' 42' WBWL
currently in Ft. Wayne, IN
--
Curt Sprenger 1987 PT38 8V92, Anaheim Hills, Calif.